Wire tuck questions

[wiggles]

I just finished my wire tuck on the passenger side  and I was trying to put the fuse box I have everythin g else done just tryin to find a place for the fuse box so I can put the carpet back and I know bus driver j and efjames have wire tucks and want to know where y'all put yours thanks

[rbwdriven]

Due to you having ac it is a little bit more challengi ng.

I think they are usually mounted on the evaporato r.
Or center console.

[wiggles]

I was going to flip the ecu to the middle of the dash and put the fuse box where the ecu was but the carpet will not do right under the middle of the dash

[EFJames]

I have my ecu mounted in it's factory location. I made brackets to mount the fuse box and such in a semi-factory looking way. I have removed heat and a/c so I have a ton of room for whatever.

[wiggles]

Yeah my ac and heat work great so I'm keeping them i might put the ecu back and the plate over it and put the carpet back and then put the fuse box under the middle of the dash above the carpet I might have to extend more wires to do it I will see if it will fit

[EFJames]

I'm sure if you removed the loom, find a spot for your fuse box and then reloomed it up you'll be fine. I doubt length would be an issue if you removed all the crap.

[wiggles]

Then I migh put it under the middle of the dash above the carpet so it's easy to get to it unless I can find a better place to put it

[SmokeyJ]

why dont you just mount in glove box

[EFJames]

That crossed my mind.. but I like storing my stuff there and not having it all in my face. haha

[wiggles]

why dont you just mount in glove box

I was thinking that but then I would have to drill holes in the bottom to run the wires through I was going to mount it up side down near the blower motor but then you can still see it I'm just going to try to put it under the dash

[Thundercat]

here's where mine is (next to the ecu)

[wiggles]

Does you carpet lay flat like it should